DEVELOPING MEASURES TO IMPROVE WORKING CONDITIONS IN CAST IRON PRODUCTION

Authors

DOI:

https://doi.org/10.30857/2413-0117.2018.2.8

Keywords:

working conditions, harmful emissions, cover, resistance, efficiency, aspiration

Abstract

The article explores the causes of working environment pollution and identifies the sources of harmful and dangerous emissions in pig iron production, along with searching for rational measures to improve the blast furnace cast house aspiration system efficiency to remove toxic gases, dust and exhaust heat. A mathematical modeling methodology for transfer process of molten iron and slag from the blast furnace to the ladle has been employed. The best practice from Zaporizhstal Steel Works on a new aspiration system at blast furnace casting yard laid the basis for the research. An aerodynamic calculation method was used to detect deficiencies in the aspiration system. Statistical method to validate the results obtained was used for constructing of graphs and nomograms. The major causes of inefficiency of the current system of covering iron and slag troughs of a blast furnace casting yard have been revealed, in particular the bypass channel for slag from the main drain trough for molten iron and high local resistance losses on iron and slag distribution (the skimmers). Total and local resistance losses in various areas of drain gutters and aspiration systems have been calculated along with estimating the locations for additional exhaust hood installation, i.e. the special zones for skimmers, the main, transfer and bypass troughs for cast iron and slag. It is proved that by increasing the aspiration efficiency contamination of the working area is reduced, thus improving labour conditions significantly. It is proposed to use modern heat-resistant concrete troughs with higher resistance and longer life service. The proposed modification of trough slabs will facilitate their replacement when carrying out repair works on trough lining and cleaning. An aspiration system model for a typical blast furnace cast house has been developed and explored. The areas and reasons behind the loss of resistance in the exhaust system of hood covering for molten iron and slag troughs are identified. Recommendations to enhance the system efficiency to reduce contamination of the working environment and improve working conditions have been suggested.

Downloads

Download data is not yet available.

Author Biographies

Вячеслав Кирилович Тарасов, Zaporizhzhia State Engineering Academy

кандидат технічних наук, доцент, доцент кафедри прикладної екології та охорони праці Запорізької державної інженерної академії

Владислав Ростиславович Румянцев, Zaporizhzhia State Engineering Academy

кандидат технічних наук, доцент, доцент кафедри прикладної екології та охорони праці Запорізької державної інженерної академії

Оксана Володимирівна Новокщонова, Zaporizhzhia State Engineering Academy

асистент кафедри прикладної екології та охорони праці Запорізької державної інженерної академії

Інна Олександрівна Ткаліч, Zaporizhzhia State Engineering Academy

асистент кафедри прикладної екології та охорони праці Запорізької державної інженерної академії

Published

2018-08-01

Issue

Section

MODERN TENDENCIES AND MANAGEMENT PROBLEMS